& 901067 pcut ct 630 This is the driver download for the USCutter PCut vinyl cutter. A retro-inspired vinyl cutter that prints high quality images that can be easily stored on a thumb drive, this cutter requires just a USB connection to a PC or Mac and a vinyl sheet. However, I can’t do the alignment of the laser for cutting and contouring by flexi The company that sold it to me said that it has a specific software to work with this plotter, but he sells and doesn’t even know the name And said that with the flexi has no way to align the laser, only the tip of the needle, which makes it almost impossible to make contour cuts.Creation pcut ct 630 Main Table of Contents. I bought a cto630 creation and managed to make cutouts in vinyl normally. If the plotter is only 3 months old I would suggest first contacting the seller to see if you can get a replacement if you can’t, you may have to talk to creation support for a replacement under warranty but I have never dealt with them so I don’t know how good they are. Saying that I wouldn’t have the first idea on how to tighten or replace the belt. It may that the belt that moves the blade left and right is slipping and you may be able to hear it slipping if you listen. After all that is done remember to press the mode button to get back to the screen for setting the X and Y axis, then press the “on-line” button and make sure the screen says on-line. To change the baud rate is a bit strange to change it to a lower speed press the + and for a faster speed press. Once your vinyl plotter is turned on you will need to press the “on-line” button then the mode button 7 times to get the Baud setting, if you haven’t guessed this needs to be 9600.
Now that is all setup you will need to make sure the vinyl plotter is setup.
Change the Output Device to the serial (COM) port you’re using it should look something like this: Next you will need to click on “comm settings” you shouldn’t have to change anything but just make sure they are the same as the following: In the manual that comes with the PCut CT 630 it says you should set the Baud rate to 19200 but I couldn’t get it working at that speed. Now open Sign Blazer and go to the cutter preferences, the Cutter should be “Creation pcut ct 630”.
0 kommentar(er)
